Carton production detector use and maintenance and minor repairs
Understand Carton Detector used in the production structure and performance, the right to master the instruments to use and a brief maintenance, repair techniques, we can extend the life of instrumentation to improve detection accuracy, but also conducive to quality control personnel to carry out quality monitoring handy. Can significantly improve the efficiency and raw material inspection and quality control carton products. The following testing on the carton production equipment maintenance and repair of simple precautions to communicate with their peers.
Brief maintenance, repair techniques To master Food Operating procedure to use, test range, so as not to affect the measurement.
Instruments and mechanical parts to moisture, rust, dust, vibration, calibration levels and types of grease into the regulations. On the electrical part of the original device, Power supply , Sensors, switches, monitors, etc. to make insulation, rodent control, temperature control, reduce oxidation, aging, leakage, short circuit, open circuit caused by electrical part of the damage.
All kinds of glassware and optical equipment to light to handle, gently, to prevent the sudden cold, sudden fever, in the strike, collision, dust and mildew. In particular, and polishing of optical parts of the mirror surface can not be handled with bare hands, to wear gloves or spinning silk pad to get soft, clean, also can only graze with a fine silk.
A variety of measuring instruments on the blade, scale, indicator to prevent damage, to keep clean and calibrated regularly by the measurement department.
Of the mechanical system due to wear, corrosion, dust, grease, break, broken, falling into foreign body, loose or improper operation caused by the active portion of a "crash", spin, vibration, operation is not synchronized, fixed screw adjustment screw , sound temperature anomalies can see, hear, measure, touch for investigation.
Effect on the fixed electrical fault occurs, the indicator is not lit, the display does not display or data anomalies can check switches, fuses, filament, electrical parts is leakage, or poor contact, and through measuring resistance, voltage, current , into a corresponding signal, replace the original device for troubleshooting questions.
Appear on the reading part of the target deformation, scale ruler wear patent leather off, vague, display abnormal signal interruption or electrical parameters, affect the normal display and accurate readings to be replaced.
Demolition equipment Instruments by analyzing the situation to judge, if there are failures, before the demolition, and carefully observed before in the hands of various components of each assembly relation. Precision assembly and disassembly procedures, the removal of complex parts for the best record in case of error recovery time. Easy removal of parts of the force should not be demolished, should use rubber Plastic , Wooden hammer, gently tap it a little loose after the demolition. Metal, rubber, glass, magnetic body parts of different material should be stored separately, at the same time prevent the loss, especially after being magnetized will affect the use of parts not to be dismantled will not be easily dismantled, their not sure the best in the expertise to solve the fault repair machinery.
Assembly after overhaul Through the damaged, incomplete, deformation, deterioration, corrosion, wear, fracture, loosening, leakage and other faults of the parts, replacement and repair of the assembly after the recovery, in accordance with the procedures stood reduction, attention is not negative, and up and down direction reversed, and the assembly to ensure accuracy within the tolerance range. To be on the level of state (zero) is not transferred can not be omitted, the use of lubricants should pay attention to the model used in lubricating oil and grease will not reverse the order.
Equipment repair installation finished, you want to be empty and the real set of trial operation, involving a direct impact on the measurement readings should also request the standard: short-tailed bird test measurement departments to ensure the equipment to detect the crime i performance data and instrument parameters to meet the requirements, the operator for use to identify, and make record keeping.
I am an expert from China Crafts Suppliers, usually analyzes all kind of industries situation, such as diamond cutting wheels , non woven abrasives.
Processing your request, Please wait....
