Repair The Old Seal Of Your Drysuit to Enjoy Its Long Life
Drysuits are used by rafters, scuba diving masters, and kayakers as well as by the boaters for keeping themselves warm and dry what time they are in a cold surroundings. Water is stopped from entering into the body of a drysuit with niceness of integrated seals positioned at the ankles, wrist plus neck side. Over time, the drysuit seals may cause breaking or tearing while the rubber aging high, making the drysuit inadequate for its anticipated purpose. You can have repaired your drysuit seals but you may need to follow some underneath steps.
a) Take out the old seals, for that expose the inner of the suit where the seals are sited by making its inside out. Watchfully cut the seal, leaving the adhered parts integral. Manage the cut straight and keep away from rough edges. Sand those edges of your drysuit to roughen them. Comprehensively clean the irregular edges using alcohol and let them dry.
b) Arrange Mixing of the glue for the seal and use on the mating areas. But first Wear latex gloves and mix balanced ratio of Cotol and Aquaseal on a dry plastic dish. Equally apply this Cotol & Aquaseal blend over the original seal then leave it exposed for ten minutes to dry. Using the old drysuit seal, turn the new seal inside exposed. Coat another layer of bonding agent to your old seal.
c) Fasten the new seal, since both old and new seals are covered using the adhesive mixture, vigilantly position the new seal and put a pressure over its glued edges over the original seal. Level out and clear out any folds or bubbles you find among the old seal and the new seal.
d) Using some sort of waxed papers support the seal to dry, precisely cover the replacement drysuit’s seal and utilize tape to protect it. Have the plastic ring, which you have developed earlier and wrap it in waxed paper. Utilize tape to make safe the wax paper and place the ring over your drysuit seal.
e) Finally after allowing the glue mixture to make well for at least 10 hours, remove the waxed paper plus plastic ring. Utilize adhesive mixture over the edge of a new seal for your drysuit. One hour later, pull out the plastic container and turn the suit outside exposed. Put in back the plastic pot and apply a light coat of glue mixture on the edges at the point an old and new seal meet. Let it get well for one day. A new drysuit can reasonably be expensive but by replacing just the seals will cost you pretty less, however will seriously extend the functional lifetime of your suit. Let gummifabrikken.com; guide you better for your Drysuit solutions.
About Author: If you are interested to know more about drysuit seals, please search our site for more in-depth information and resources.
Processing your request, Please wait....
