iPhone Repair: Improve Any iPhone Charging Dock
The iPhone 4 is an wonderful gadget which is utilised worldwide. On account of its widespread use individuals usually run into hardware troubles. Because the iPhone has a big glass screen and is effortlessly broken this can be presently the most typical iPhone repair being performed. Even so, a much less well-known iPhone repair that nevertheless takes place fairly often is the charging port repair. This portion often breaks from widespread wear and tear or from becoming deflective. Also, this iPhone repair method will fix a faulty or damaged microphone which is typical when the person you are talking to on the phone can not hear you. By replacing 1 iPhone part this repair truly fixes two issues.
You’ll need the following tools to perform this iPhone repair: Pentalobe screwdriver, Phillips screwdriver, flathead screwdriver, plastic pry tool.
Step 1.
According to your iPhone you will need to make use of either the Phillips or the Pentalobe screwdriver to get rid of the two screws situated on the bottom from the iPhone. These two screws are accountable for securing the back cover.
Step two.
Soon after removing the two bottom screws, the subsequent step is always to remove the back cover. Push the cover down and lift it out. Be sure that when taking the cover off you do not press down on it as this can break it.
Step 3.
Use your Phillips screwdriver to remove the two screws holding the metal plate and charging port flex cable in location. Right after you take the screws out, lift the plate out from the phone.
Step four.
The subsequent step demands you to take away the screw keeping the battery flex attached for the motherboard. When you eliminate the screw, use your plastic pry tool to get rid of the terminal from the board.
Step 5.
Pull the clear plastic tab to pull the battery out of the iPhone. You may need to use the plastic pry tool to assist get the battery out.
Step 6.
The subsequent step requires you to remove the metal clip that keeps the iPhone antenna in location.
Step 7.
Use your plastic pry tool to disconnect the charging port flex cable from the terminal.
Step 8.
You will need to take away two much more screws that hold the speakerphone and antenna assembly in location. Get rid of the assembly when this can be performed. Take wonderful care when removing this in order that you don’t harm the motherboard.
Step 9.
There is going to be two much more screws holding the charging port flex in location. The tool for the job is going to be the Phillips screwdriver.
Step ten.
You will must take away the residence button flex cable by lifting the plastic tab up.
Step 11.
Subsequent you’ll need to get rid of the small rubber cover which can be glued over the microphone flex.
Step 12.
Remove the flex cable out with the iPhone. Because the flex assembly is glued towards the bottom in the iPhone it would support to make use of the flathead screwdriver to lift it out.
Use this repair guide in reverse order to full this iPhone repair. Be extremely careful when performing this repair to make sure that you simply don’t damage the motherboard or any other surrounding components.
Remund Dunton is a proud contributing publisher and creates reports on several subjects including iPhone repair. You might read more of his content articles located at http://www.irepairsolutions.net.
Processing your request, Please wait....
