Granulating equipment FAQ – pellet mill – the pharmaceutical industries
1, grain production machine running some time after the decline, what to do?
A: 1. Check ring mold, pressure roller is worn, such as wear and need replacement; 2. Check whether the model loop hole was closed, so please clean up; 3. Check motor belt tension, such as the need for belt too loose Tension; 4. check steam pipes, see Traps Whether the normal drainage. General granular machine to work long hours, the hydrophobic Valve Because of the contamination and the effect of poor drainage, resulting in large water quenching.
2, sheep UMT series particulate lubricating oil separator device over time, lubricate the handle to turn the difficulties caused by forcibly pulling the handle breaking, not oiling, how?
A: 1. Pomace oil there is small and not clean up time will be stuck in the lubrication of moving parts, resulting in difficulty turning the handle; lubrication filters should be cleaned regularly.
2. When the sub fuel injection device Note finished the first hole, hole in the steering when the next note should first close the gas source, to be aligned when the second injection hole can open the gas source. If the conversion process, does not close the gas source, it will be difficult to handle rotation, or even lead to sub-oil cooler, "0" ring damaged phenomenon.
3, 600 grain machine using the long, spindle oil line to play no oil, how to handle?
A: 1. First clear the spindle and rotor gap in residual materials.
2. Clean up the oil filter in the filter.
3. Removing grease oil block, with a diameter of 4mm length 497mm (effective length) of the hollow tube connected to the compressed air into the hole hole to clean up.
4. Debridement Pump The drums. 5. Cleaning a block down fat, grease installed a new oil block after the start with a bucket of Da You, check the availability of fuel leakage site.
6. Check whether the rotor back-end oil seal leakage, if any need to change seals.
7. Dayou 10 minutes after the open air for approximately five minutes after the call back to the main shaft down a clean new oil.
4, MUZL600 particle machine set up sets of safety pins often spin axis caused by disc displacement, how to handle?
A: 1. Release the two safety pins fixed bolts, four bolts were removed and two safety pins.
2. Loosen up the 10 put on and remove the four screws, four screws were used to screw it up put on the top wire of the four holes and set up the top out about 1mm, then remove the remaining the six screws.
3. Release the trip switch the two screws remove the limit switch, then remove the safety pin plate.
4. Check whether the spindle on the signs of wear, there are signs of repair with a file first and then fine sandpaper deburring have traces of the spindle position polished smooth. Then check whether the set up and wear, such as badly worn must be set up to replace the wearing parts.
5. The spindle with gasoline, set up and clean up sets of locking screws.
6. Rotating spindle to the correct position (large deflection blade position in the clockwise 5:30)
7. To set up the safety pin installed in the tray to put on locking screw in the screwed up one or two teeth (when installed on the following four sets up the location of the top wire, 10 screw threaded hole 10 that is aligned can)
8. To set up the safety pin with the plate and installed in the spindle, then install two safety pins (not to screw tight the safety pin in place)
9. Read < >, The book has set up locking screw locking method must be in accordance with the method my company to do the assembly, augmented with 500mm long rods lock in place all the screws.
I am China Manufacturers writer, reports some information about inkjet paper roll , gloss inkjet paper.
Processing your request, Please wait....
