Often encounter the solenoid valve problem
Solenoid valve may not open due to power outage, and the pressure is uneven, and dirt under the diaphragm, corrosion, or missing components of the file to burn out.In an attempt to diagnose the problem before taking any steps to address the problem. The most important parts that must be evaluated in this process is the valve of the diaphragm, the diaphragm spring, power, coil, flow control adjustment, valve entrance port, the outlet port of solenoid valve bleed port.
Solenoid valve is a device used to control the flow of liquid or gas in the system. Is powered usually by electromagnetic energy in the file. Solenoid valves useful in converting electrical energy into mechanical energy.Specially designed valves, 3 way for the basic operating cylinders and valves are operated by air traffic control. Can be solenoid valves, four way also be useful in operating valves that have solenoids 2 in.. Usually made solenoid valves consists of stainless steel, Teflon, and brass corrosion and materials that have different characteristics heating.
Each time a valve closes or opens, you may hear the sound of annoying beats. In other cases, can be heard buzzing sound when you run the solenoid valves. These can be errant valve votes because of the difference in the entrance or exit pressure within the system. Beats water when you open the valve can be caused by high pressure liquid through a small tube inserted into the holds. Installation of tube T-piece before the air can help cool and reduce noise impact. You can also increase the dimensions of your pipes to reduce the speed of your components liquid. Increasing the size of pipe to be a nice way to ease the pressure at the entrance of the valves as well.
Can fail to close the valves in some cases. This can be because there is evidence of the ride, and the difference of pressure and force the remaining rolls, damage to the engine tube, upside down and damaged valve seats, and some components are missing. Make sure to thoroughly check your wiring, lead communications components and the diaphragm. You can also try to raise the file a bit to see if the electromagnetic field exists. If you have ever inverted diaphragm, it may be wise to renewal of the item correctly before being replaced with new ones.
Can be caused by these problems through the file a short circuit, and the slow motor coil, and the effort and the media wrong and high (gases and liquids, and others) temperatures. To avoid the wrong supply voltage, be sure to check the compatibility of the file with power supply. Verify the presence of moisture and replace if necessary. Replacement of any imminent harm, structures and media compatibility with your valve. It should be immediate and structures muslim replaced. And structures are cleaned with dirty strainers r type. Do not forget to move the solenoid valve in the colder region, or may increase the ventilation around the valve and the file.
Processing your request, Please wait....
