www.jewelora.com tell you something about fashion jewelry tools
When you are first beginning to work with jewelry you will need only a few jewelry tools and pieces of equipment. Buy tools only as you need them. There is no need acquire the full range when you are beginning.
There is no need to buy sophisticated work bench. An old table will suffice, as long as it is reasonably sturdy and does not wobble. Make sure that the table is a comfortable height. When you are working your elbows should be able to rest easily on the surface of the table is a comfortable height.
Most jewelry polishing can be done by hand, especially at first. If and when you acquire a polishing motor, make sure that is has its own housing or that has an integral dust extraction system. The dust created by jewelry polishing is dirty and gets everywhere. The following jewelry tools and equipment are those you will need to get started. Buy other items as you need them so that you gradually acquire a fully equipped workshop.
Jeweler’s saw
This is the first jewelry tool to buy and the one you will keep forever. Buy the best you can afford. Blades, which are available in packs of 12, range in grade from 4/0, through 0 down to 0/6. To begin with, buy grade 1,0 or 0/1.
Large half-round file Use this for cleaning up the inside surfaces of rings and inside curves.
Flat-nosed pliers
These are for holding, bending, and forming. Buy two different sized pairs and make sure they are comfo0rtable in your hand.
Serrated-edge pliers
Although they will leave a mark when they are used for gripping metal, they are essential for pulling wire straight or through a draw plate.
Ring mandrel
This tapered steel rod is used for shaping rings after soldering.
Wooden mallet
Use this to shape and flatten silver. It will not leave marks on the metal.
Soldering torch
Make sure that there is somewhere near the soldering area to keep the torch and that when it is in use the flame is always directed toward the soldering block.
Charcoal block
Items that are to be soldered are placed on the block.
Wet and dry snappers
Keep a good selection in stock, beginning with grade 240 and working through grades 400 and 600 down to grade 1200.
Safety pickle, alum, or sulfuric pickle
A pickle of some kind is needed to clean metal after soldering. Liquid metal cleaner ideal for polishing when the piece has been finished.
Leather or felt stick
The final stage in polishing is buffing on a stick.
Water
Wherever you work, make sure that you have easy access to running water
you can get more information at the site http://www.jewelora.com/
In www.jewelora.com, We are a leading wholesale trader for wholesale jewelry including imitation jewelry and wholesale fashion jewelry.
Processing your request, Please wait....
