crown molding
Buying Crown Molding is expensive. Don’t hold wasting your cash since you don’t know the proper way to reduce and install it. Save money by:
1. Learning to chop test pieces that can prevent one hundred’s of dollars
2. Discover out what tools to make use of that already have the setting for reducing Crown Molding. on them.
3. Learn to do it yourself and save tons of money.
By following these simple but effective steps, you will be able to install like a professional and not waste time on frequent set up mistakes.
So let me guess. You went out and acquired some crown molding out of your local hardware store and might’t determine learn how to reduce the corners. Am I right?
The final time I purchased any Crown Molding I paid round 10.00 per foot for it. It wasn’t low cost! So each mistake you make on the miter is going to price you at the least 10 dollars.
First I need to briefly go over the 5 commonest mistakes when putting in Crown Molding
.
1. Mitering the corners at a 45 degree angle and assuming it’ll fit.
a. Crown Molding will not be laid flat towards the wall. It is truly angled when it is installed. Due to this it won’t line up at a forty five degree angle.
2. Assuming there is just one angle wanted at every miter cut.
a. Not only do it is advisable change the horizontal angle of the blade however you will also want to alter the vertical angle. Relying on the kind of saw you have will decide whether or not you can do this or not. Most compound miter saws have this capability now, however in case you have an older saw you might not have this feature. For those who don’t have this function and you are looking at getting a new compound noticed then try my blog publish on refurbished power tools on the right side of this page. For video instructions on making this complicated cut please Click Here.
3. Using a hammer.
a. I know this one seems somewhat unusual so let me explain. I am writing this text for the newbie woodworker. So I am also assuming you don’t have TONS of experience doing one of these work. Like we talked about earlier than Crown Molding
may be very expensive. It’s additionally not essentially the most sturdy wood. It’s very thin and flimsy. Utilizing a hammer without having loads of experience will create divots within the molding. These can’t be fixed. That’s proper you’ll have to buy yet one more piece of wood.
4. Understanding the place to put your nails on the wood.
a. There are only some places to nail that won’t crack the molding. What you want to bear in mind is this board is at an angle. In case you shoot a nail in the course of the board you’ll crack it if not break it. One of the best locations to place your nails are at the high and bottom. Depending on what kind of molding you might have bought you may have an choice to cover your nails very simply in the creases and/or curves of the wood.
5. Holding the Crown Molding at an angle in your miter saw when reducing it.
a. This is by far the most common mistake I see when someone is trying to put in crown molding. You’ll burn via more wood questioning why your angles aren’t popping out right because of this one mistake over every other listed here.
Now I have Installed A LOT of crown molding in my life. It isn’t easy and it’s best if you can see it being done before you install it. This will prevent time and money. Please Click Here. to view movies on putting in crown molding.
Learn more tips of woodworking at Wood Workers Blog
Processing your request, Please wait....
